彩鋼復合板在我們的日常生活中可以經常看到，具有方便施工、質量輕、強度硬的特點。復合板的膠粘劑不僅操作方便，粘合強度高，而且采用科學的預聚改性工藝，使膠水初粘性更好，粘結更牢固，下面就來介紹一下它的使用方法。

Color steel composite panels can be frequently seen in our daily life, with the characteristics of convenient construction, light weight, and hard strength. The adhesive for composite boards is not only easy to operate and has high bonding strength, but also adopts a scientific pre polymerization modification process to improve the initial adhesion of the adhesive and make it more firmly bonded. The following will introduce its usage method.

1、彩鋼復合板板材的粘膠面要求清潔，干燥，無油脂。

1. The adhesive surface of color steel composite board should be clean, dry, and free of grease.

2、膠粘劑主劑在取出前要攪拌均勻。

2. The main adhesive agent should be stirred evenly before removal.

3、彩鋼復合板板材施膠面如有涂層，油漆等輕先做試驗，膠水施膠溫度為5度-40度之間。

3. If there is a coating or paint on the adhesive surface of the color steel composite board, the test should be conducted first. The adhesive application temperature should be between 5 ° C and 40 ° C.

4、復合前要確保膠水表面沒有干，以防影響粘結效果。

4. Before compounding, ensure that the surface of the adhesive is not dry to prevent affecting the bonding effect.

5、常溫（25度）壓合需要4個小時，操作時根據實際溫度延長或縮短壓合時間。

5. Pressing at room temperature (25 degrees) takes 4 hours, and the pressing time should be extended or shortened according to the actual temperature during operation.

6、膠水初始固化后，把彩鋼復合板放到一邊，一周后方可用于工程。

6. After the initial solidification of the adhesive, place the color steel composite board aside and wait for one week before it can be used in the project.